So far GUI on RED is OK on v9.1.
To recap the changes:
- Disabled "Auto Amplitude Filter"
- Enabled LEDs off when LCD off
- Reverted to v9.1
- Display: Auto off after 60 sec.
I suspect that v9.2 might be OK, without the already noted issues. I think that the disabling of the Auto Amplitude Filter was the most effective, but others certainly helped.
Greg H.
Although with the countermeasures mentioned, it seemed better, this morning it was back to its old tricks again with a monochrome header only GUI display. Back to v8.4, which is where it is going to stay.
I had some severe unrelated problems with an IP address conflict that was wreaking havoc on my LAN. This was the cause of my inability to re-flash. That was an unholy combination of a power outage, new smart TV and DHCP. Got that sorted.
Greg H.