I have followed the directions (page 28 of console manual) to try and adjust barometric reading. However The press and release 2nd then press and hold set only brings me into the master setup routine. I have tried all sorts of variations but no luck. I believe the instructions are wrong but I don't find anyone else reporting this problem. Suggestions?
Note: I am trying to tweak the the setting from 30.67 to 30.45, not change from NOAA, ALT, None
to recap:
Calibrating Barometric Pressure
Before calibrating the barometric pressure, be sure the station is set to the correct elevation.
See “Screen 10: Elevation” on page 11 for more information. Find the nearest source of
barometric pressure, such as a local airport, to get a current barometric pressure.
1. Press BAR to select barometric pressure.
2. Press and release 2ND, then press and hold SET. The barometric pressure variable blinks.
3. Continue holding SET until the Weather Center reads “SET BAR.”
4. Press the < and > keys to select digits in the variable.
5. Press + and - keys to add to or subtract from the digit’s value.
6. Press DONE to exit calibration.
If you don't see the current reading 'blinking' start over.