« previous next »
Pages: [1]   Go Down

Author Topic: Posting Air quality readings to Cumulusmx using ecowitt http protocol  (Read 206 times)

0 Members and 1 Guest are viewing this topic.

Offline watsonm

  • Member
  • *
  • Posts: 38
Posting Air quality readings to Cumulusmx using ecowitt http protocol
« on: August 06, 2022, 02:04:16 PM »
I am trying to use the Ecowitt http posting function to add the air quality measurements to my weather station software.

I cannot find the appropriate "tags" to enter the data. For example the barometer data is entered by

 'baromrelin' :  pressure

where pressure is the reading from my Raspebrry pi attached sensor.

Can anyone point me to a list or post an example data stream ...

Many thanks  MIke

(also posted similar to cumulsmx forum which is the software I am using)
Logged
Regards Mike

Raspberry Pi 4
Directly connected : BMP388 pressure sensor.  DHT22 For internal Humidity Sensor temp
Wireless connected: 3 Temperature Transmitters(WS2083), WH57  Lightning Sensor, Fine Offset Solar sensor  (stand alone)

Offline watsonm

  • Member
  • *
  • Posts: 38
Re: Posting Air quality readings to Cumulusmx using ecowitt http protocol
« Reply #1 on: August 06, 2022, 02:10:24 PM »
Typical !!!

after spending many hours trying I eventually managed to get the data in a few minutes after posting!!!   8-)


Logged
Regards Mike

Raspberry Pi 4
Directly connected : BMP388 pressure sensor.  DHT22 For internal Humidity Sensor temp
Wireless connected: 3 Temperature Transmitters(WS2083), WH57  Lightning Sensor, Fine Offset Solar sensor  (stand alone)
Pages: [1]   Go Up
« previous next »