Hello. I've been having off and on issues with my VP2 for a while now around the wireless. I'm pretty sure it's an issue of the environmental conditions but that's neither here nor there. From doing some digging looking at PCBs online, it looks like the cabled PCB is literally the same as the wireless, just sans a holder for the battery and the wireless transmitter piece. Same with the Wireless Envoy i'm currently using. It looks like it retains the cabled port, even though it has a wireless connection. Unfortunately this station is about 70 miles away from me so I can't just play around with it to figure it out. But does anyone know if I can connect the comms port up to the PCB on the wireless ISS board and then into an envoy and have it work? Or does the firmware of the PCB basically shut off that port when the wireless transmitter is installed? I'm just thinking through some ideas and wondering if it's possible without replacing the entire PCB assembly with a cabled one.