Weather Station Hardware > Blitzortung

Saving to Flash

(1/5) > >>

Ian.:
Hi,

I have built RED and it's in interferance mode as the gain is 10*10, I've set the antenna type and the message is to save to Flash and reboot, how do I do this, is it a matter of connecting to the ST Utility and looking for a particular setting, sorry if its a noddy question, I a novice in these matters.

Thanks

Ian

Cutty Sark Sailor:

--- Quote from: redpis on August 10, 2013, 07:48:44 AM ---Hi,

I have built RED and it's in interferance mode as the gain is 10*10, I've set the antenna type and the message is to save to Flash and reboot, how do I do this, is it a matter of connecting to the ST Utility and looking for a particular setting, sorry if its a noddy question, I a novice in these matters.

Thanks

Ian

--- End quote ---
. On the controller Screen? Yes, save to flash memory. You don't have to do anything else. You don't have to actually save it, either, you could hit apply, and it will operate with those settings until it is reset. Then it goes back to whatever the default is.
If you save it to the flash memory on  the board, it becomes your new setting. When/if the controller reboots or resets it will remember your setting. Otherwise it will restart with the settings that are presently programmed.

Ian.:
The message to save to falsh is not on the controler (sorry for the confusion) it is on Blitzortung Controller 10.3 software which I have accesed via my iPad, no messages are displayed on the LCD of the controller itself, I have tried pressing and holding teh Blue buttion in the hope of finding a save menu, but to no avail.

Ian

Cutty Sark Sailor:

--- Quote from: Cutty Sark Sailor on August 10, 2013, 08:05:33 AM ---
--- Quote from: redpis on August 10, 2013, 07:48:44 AM ---Hi,

I have built RED and it's in interferance mode as the gain is 10*10, I've set the antenna type and the message is to save to Flash and reboot, how do I do this, is it a matter of connecting to the ST Utility and looking for a particular setting, sorry if its a noddy question, I a novice in these matters.

Thanks

Ian

--- End quote ---
. On the controller Screen? Yes, save to flash memory. You don't have to do anything else. You don't have to actually save it, either, you could hit apply, and it will operate with those settings until it is reset. Then it goes back to whatever the default is.
If you save it to the flash memory on  the board, it becomes your new setting. When/if the controller reboots or resets it will remember your setting. Otherwise it will restart with the settings that are presently programmed.

--- End quote ---

--- Quote from: redpis on August 10, 2013, 08:18:09 AM ---The message to save to falsh is not on the controler (sorry for the confusion) it is on Blitzortung Controller 10.3 software which I have accesed via my iPad, no messages are displayed on the LCD of the controller itself, I have tried pressing and holding teh Blue buttion in the hope of finding a save menu, but to no avail.

Ian

--- End quote ---
Yes, I was referring to the tools menu on the system software you view. When in "settings" page, all I do his hit 'apply' to adjust temporarily. And that's all. If I go to tools, save to memory will write it to the memory until it's changed and resaved as something else. 

Cutty Sark Sailor:
Hmmm. a thought. Have you updated the firmware to 2.4?

Navigation

[0] Message Index

[#] Next page