Hi!
The error has just been corrected. The v1.1.9 should now be downloadable with WS View.
Oliver
Yes, it was updated after two corrections.
Now testing if it continues to update ecowitt and custom server.
Wim
Now the WH1900 reported correctly for longer periodes.
Also removing the USB power the WH1900 on battery power runs in "power saving mode"
=> continues to upload the primary outdoor sensor.
=> uses minimal WiFi task
=> but still can be accessed by ws-view after pressing the light button
There is one remaining "problem for some situations" in USB power mode
It always uses the data from a "nearby" WH32 temp/hum sensor.
Good feature when your own outside array has a failing T/H sensor.
Sadly on the WH1900 one can not disable the WH32 in ws-view
So a nearby WH32
always replaces the WH1900 outside temp/hum even when the "neighbours" WH32 sends "intermittently" or sends garbage.
Systems should be build that:
Never a sensor can overwrite a primary sensor without allowing the station-owner to disable a "foreign" sensor.
There are two sensors which should be better supported:
- inside temp/hum/pressure sensor standard with a HP2650 or 2551 console
- outside "main" temp/hum sensor often used with separate wind / rain sensors
All "consoles" should be allowed to select such a sensor if those special sensors are found
All "consoles" should be able to disable such a sensor as their own primary sensor is better.
Why: One real-life example discussed on this forum a few days ago.
A GW1000 is placed as near to the outside sensors as possible.
But that often is the wrong place for "inside temp/hum" which is integrated with a cable to the GW100/GW1100/GW2000
Even if you use a T/H/P
the GW1000 refuses to acknowledge its existence.
That is why @olicat's code and my receiving code can use a normal extra sensor to replace the "integrated"inside or outside sensors.
Those settings belong in the ws-view setup directly at the source of receiving the weather-values.
That way we make sure that weather-data uploaded to external sources all have the same values.
Wim