I have a couple RM Young 05103 monitors on my tower. For years it happily fed a Texas Weather Instruments 8000 without a hitch. As far as I know, I've not put in any new AC devices (except an OLED TV) or dimmers or welders or whatever. Unknown if there are neighbors (5 acre lots) with anything new.
A few years ago I had noticed that, with no temporal pattern that the wind speed would take off to 100 mph or more. This makes almost all data unusable, and certainly embarrassing to publish on the net, and negates MesoWest sharing.
At first it was rare, but now seems to happen daily. I had swapped out the TWI 8000 for a WRL32 with minimal if any noticeable help.
I tried sticking my scope on it to watch and not having time to be in the shop all the time, and when these errors occur they are only for a few seconds to a minute at most, so I've not seen anything.
I've tried to put a ferrite choke over the input closest to the display, with no benefit, but I only had access to one style and frequency.
The Young manual only speaks to length of cable for the direction vane, nothing about the speed sensor.
I should have mentioned that the monitor puts out 3 AC pulses sine wave per rotation, and the output is 90 Hz or 1800 rpm at 19.7 mph, but I don't have any amplitude numbers to give.
Any thoughts from others using these about errors introduced by electrical noise? Lightning doesn't affect it.
Dale