I update the post by communicating an update made to the WeatherWizz dashboard. A new feature has been implemented that allows you to view on the dashboard itself as well as the battery voltage also the mode in which the station works.
Let me explain better, if the station is below certain voltage values, some parameters will not be detected to help recharge the battery, as illustrated below:
-
Mode 0: voltage ≥ 2.455• All sensors are enabled and operating at peak performance
-
Mode 1: voltage ≤ 2.415 from mode 0 or ≥ 2.41 from mode 2 • Wind sampling interval set to 6 seconds
-
Mode 2: voltage ≤ 2.39 from mode 1 or ≥ 2.375 from mode 3• Wind sampling interval set to one minute
-
Mode 3: voltage ≤ 2.355• Wind sampling set to 5 minutes
• The sampling interval of all other sensors is set to 5 minutes
• Lightning sensor disabled
• Rain touch sensor disabled
Then in the dashboard now next to the battery voltage value, also check the mode in which the station is working and if in the case of mode 3 the values that are not detected are colored red, therefore very practical to view.

