1
Davis Instruments Weather Stations / Re: Weather Link live hardware is not working
« Last post by hdtvluvr on Today at 10:02:21 AM »Is there a window between the Weather Link Live and the station? Did you install low e glass?
might be worth observing - but if there is an intermittent short time connection issue e.g. router, internet access etc. based, the icons may still disappear aknowledging this situation.
No idea how frequently this status is checked by the console firmware.
If it keeps on repeating, will be good
a) to check your network infrastructure
b) report the finding to support@ecowitt.net
I think that's the WS85 sensor:What does battery=9 mean? 0.9V?
{ "img": "wh85", "type": "49", "name": "Wind & Rain", "id": "FFFFFFFE", "batt": "9", "signal": "0", "idst": "0" },
sensorID 0x31 = dec 49 (type is the sensor #) - including the WS85 there are 49 sensors possible assuming the max number of each is registered
result of http://IP-address/get_sensors_info?page=1 on a GW1200 1.3.0 resp. a WS3910 on 1.2.9
Heh, good luck mate!that's one of the reasons why we recommend to put the cable inside the pipe the WS90 is fixed to - our WiKi shows how to do this
The cockatoos nibbled off the auxiliary power cable to my WH-90 within 24 hours of installation. Fortunately I’ve found no need for it as frost isn’t a common issue in my corner of Queensland, but it was illuminating to see how quickly they identified that cable as a somewhat expensive bird enrichment toy. They’ve started work on chewing the silicon band around the top of the WH-90, unsure if this is likely to cause me problems or not.