Weather Software > Meteohub/Meteobridge

v6.0 - Unable to edit hourly rain values. **solved**

(1/1)

monymony:
Had to make an manual adjustment to my rain totals and when I went to ADMINISTRATION > EDIT HOUR DATA and then to the current hour (7:00) I would make my adjustment and get the confirmation the update was successful.  Then when I would refresh the page the edited value would just show 0.00in.  Tried a couple times and even did two system reboots and the update would not be saved.

Reverted to v5.9 and was able to make the change without a problem.  The attachment shows where I was trying to edit.

System Info (after reverting to v5.9):
Platform:   Raspberry Pi 4 Model B 
RAM:   3895 MB total, 3772 MB free (3% used)
Storage:   WD SLC, 7.1 GB total, 7.0 GB free (1% used, 224.4 yrs)
SW Version:   Meteobridge 5.9 (May 26 2024, build 3388), FW 1.4

docbee:
No Problem with 6.0 here. When you click on the value you can enter a new value. When you click onto the timestamp the entry is erased.

davidmc36:
If the hour that you are trying to edit has not expired, you can't edit it.

ie: you must wait until after 7 to edit the 6 to 7 time frame.

monymony:

--- Quote from: davidmc36 on December 02, 2024, 07:31:43 PM ---If the hour that you are trying to edit has not expired, you can't edit it.

--- End quote ---

Interesting... I will update to the latest version and try things again now knowing a bit more about the behavior.  Thanks for info.

UPDATE: Confirmed working - waiting until the next hour to edit resolved the issue.  Now running v6.1.

Navigation

[0] Message Index