Weather Software > Other Weather Software
Wind Speed on Steelseries Gauges
(1/1)
bob_linux_user:
Here I am again. Hope I do not wear out my welcome. I noticed that my SS wind gauge pointer always displays the wind gust instead of the current wind value. Is this by design or a problem. I had found a problem in ajaxWDwx.php where the current wind displayed was using the array value [2] instead of [1] which caused the current wind to display the wind gust. I dug into the code some but have not found a similar problem. Any one seen this issue.
System Specifics:
Debian 9 OS
weewx engine
wee_extension WD (testtags, clientraw, clientrawextra)
wee_extension SteelSeries Gauges
wee_extension forecast
Thanks
Bob
Update:
I managed to correct the issue. I am sure that this is a workaround but I do not see any adverse effects. I modified gauge-data.txt.tmpl and changed the following:
From
"wlatest":"$current.windGust.formatted",
"wspeed":"$current.windSpeed.formatted",
To
"wlatest":"$current.windSpeed.formatted",
"wspeed":"$current.windGust.formatted",
Anyway it now work..
Thanks
Bob
Steve Culp:
I managed to correct the issue. I am sure that this is a workaround but I do not see any adverse effects. I modified gauge-data.txt.tmpl and changed the following:
From
"wlatest":"$current.windGust.formatted",
"wspeed":"$current.windSpeed.formatted",
To
"wlatest":"$current.windSpeed.formatted",
"wspeed":"$current.windGust.formatted",
Anyway it now work..
After this change I noticed the wind reading was corrected but there was no longer a pink range highlight from wind speed to gust speed.
On my system, changing both to "wlatest":"$current.windSpeed.formatted"
"wspeed":"$current.windSpeed.formatted" brought the pink range back. Current wind is 10 gusting to 13
[ You are not allowed to view attachments ]
Navigation
[0] Message Index
Go to full version