Thanks johnd ... here is more detail:
1) I have to assume that the WLKs are the same as what I have in the BULLETIN tab of 6.0.5 of the PC software. I can see several gaps there .. but it isn't all that bad. I just don't understand why they have to make it so complicated for doing uploads; For that matter, I think (jmho) that we should be able to grab the "basic" data (if that's all we want), and export from anywhere, and it should be like GENEALOGY DATA that can use GEDCOM for instance for uploading into various Family Tree programs. Same idea. All of those are very complicated too, even though they're not "firmware" based usually...
2 - 3) The issue that is on WLIP, the way some of the DISPLAY tools the info is vastly different than the way WLL does ... i can add a few screen shots to show explain better. Basically WLIP doesn't care which wind sensor connection/device you have (mine is NOT on the ISS- but rather on a separate roof mounted sensor transmitter with it's onw solar panel), it assumes it belongs with the "PRIMARY" setting of the ISS (if that's what you have set) -- so WIND data is displayed on smart phone apps as "the" wind info. On my WLL, I only see WIND info on the "extra" sensor" display section, because WLL is smart enough (unfortunately) to keep things all separate. There needs to be a way to tell the different APPS as well as probably what data you want to upload to WCOP/WU what devices to report for which data explicitly rather than hoping that it gets it right...
4) when i was using WLL as the upload to cwop and wu, only the BAR was being reported, because that's the only item on the WLL itself; none of the other sensors were being picked up, especially the outside temp off of my ISS
5) Nope ... not expecting those features to be migrated to WLIP, other than for the value that would have in enabling the feature for folks who don't have WLL
I have one (now) so i'm all set.
So there you have it... does that explain some of this a little better?
John