Author Topic: Atlas thermometer connection socket  (Read 155 times)

0 Members and 1 Guest are viewing this topic.

Offline İbhlln

  • Member
  • *
  • Posts: 16
  • Acurite Atlas
Atlas thermometer connection socket
« on: September 11, 2019, 04:09:55 AM »
You can see Atlas's thermometer connection under the panel, too ?is it affected by rain?

Offline nincehelser

  • Forecaster
  • *****
  • Posts: 3178
Re: Atlas thermometer connection socket
« Reply #1 on: September 11, 2019, 08:58:47 AM »
You can see Atlas's thermometer connection under the panel, too ?is it affected by rain?

Is this what you are referring to inside the pagoda?

 [ You are not allowed to view attachments ]

If so, it keeps it well shielded from rain.

 [ You are not allowed to view attachments ]

 

Offline İbhlln

  • Member
  • *
  • Posts: 16
  • Acurite Atlas
Re: Atlas thermometer connection socket
« Reply #2 on: September 11, 2019, 09:44:07 AM »
Where the socket stays when you connect

How can I see your connection
« Last Edit: September 11, 2019, 09:55:17 AM by İbhlln »

Offline nincehelser

  • Forecaster
  • *****
  • Posts: 3178
Re: Atlas thermometer connection socket
« Reply #3 on: September 11, 2019, 11:42:08 AM »
That socket plugs into a jumper that runs to the circuit board in the electronics bay.

That socket is there so that you can easily service or replace the temp/humidity module if needed.

I don't have a picture of the jumper connection, but here is where it ultimately ends up in the electronics bay.  It's the connection labeled "TEMP."

 [ You are not allowed to view attachments ]


Offline İbhlln

  • Member
  • *
  • Posts: 16
  • Acurite Atlas
Re: Atlas thermometer connection socket
« Reply #4 on: September 11, 2019, 12:14:38 PM »
Under padoga socket it looks wet from the rain

Padoga altındaki soket kavşağının yerini gördünüz mü
Just inside the shutters

Offline nincehelser

  • Forecaster
  • *****
  • Posts: 3178
Re: Atlas thermometer connection socket
« Reply #5 on: September 11, 2019, 12:48:39 PM »
I doubt that will be any issue. 

The plastic connectors cover and separate the conductors pretty well.