VP2 channel 2 not reading on VWS

[stevebrtx]

I've started testing the new VP2 and the ISS Hum was about 30 points high so I calibrated it down, but the Temp/Hum for the 6382 remote is not showing on VWS. I've got it set as station 2, it shows receiving and indicates on the console, have been through setup a couple of times, but nothing is coming through, what did I miss? Even reinstalled VWS.

Later: Don't know why, but the ch 2 Temp started working and when I check VWS Settings/Vantage Pro Accessories it shows Temp Channel as Temperature 3 and Hum Channel as Humidity 2. It's a puzzle.

Second opinion? Ok, back to the original problem, the Station 2 is sending, the console is receiving Ch 2 Temp/Hum and VWS is seeing Ch 2 Temp, but not humidity, so we're just a little lame, not totally incapacitated.

[dalecoy]

This probably isn't a Davis Hardware issue.  You might get better answers in the VWS forum?

[mackbig]

Steve
Check your new post in the VWS section, if I am correct its not a davis hardware issue, but it is in fact a davis setup issue.

Andrew