Daily High Temp Incorrect

[Stetson1]

Just noticed it updated my daily high temp at 2:01pm saying it was 55.6 which is not possible since the temp has not been over 39F today. Any ideas why this happened and or how to correct this erroneous data?

Todd

[Weather Display]

what weather station type?
which version/build of the software?

(both those info should always be provided)


you can reset via action, reset selected daily extremes

[Stetson1]

Sorry, it is a WH1080 clone and I am running WD 10.37R, not sure of the build number (not home now). If I look through the clientraw files I don't see that temp anywhere. Where does it get that number from, seems like it was just random?

Todd

[Stetson1]

A side note, I have been seeing my humidity normal most days, then getting    -21159283% which screws everything up. WD 10.37R b00 is the version, never had this problem prior to upgrading to this version. Any way to correct these erroneous entries?

Todd

[Weather Display]

where are you seeing that humidity reading exactly?
in the clientraw file maybe?

not sure why you are getting problems with the version you are using with the weather station type you have,...as there was no changes made for that station type
try maybe resetting the weather station console

[Stetson1]

The reading is not showing up on the console, just every now and then when looking through the station monthly reports. It's weird that it only happened in December. Unfortunately it pooched the data averages for the month unless I can clean it up.

Todd

[Weather Display]

you can edit the logfile directly
(i.e 122011lg.txt)
then convert that logfile to data file
via action, convert WD logfiles to data files

to fix the data

used for the averages/extremes/noaa reports, etc

also you can add data limits to weed out data spikes, etc
(which can sometimes occur from electrical interference between the console and the pc (you could try adding RF baluns to the cable between them)

[Stetson1]

Will try that tonight when I get home. Thanks for the help.

Todd

[Stetson1]

No luck, found the bad entry, corrected it and did the convert. Monthly data for 12/4 still shows the -211xxxx% number. You mentioned setting limits to weed out data, how is that done?

Todd

[jmcmurry]

You mentioned setting limits to weed out data, how is that done?

Setup - Universal Setup then the Limits tab is the place.

When you edited the log file, did you have WD turned off, I think it should be?  Maybe that bad entry is back in there again?

- Jim