Weather Station Hardware > Hydreon RG-11 Optical Rain Gauge/Sensor
RG11 connected
miraculon:
I interfaced my RG11 with my Davis Temp/Hum (6382) yesterday. I changed it to "rain gauge emulation" mode (was "it's raining") and patched it into the Rain channel on the Temp/Hum.
It works well with the green LED indicating "tips". So far it is running about 2x the Davis gauge. Here is the Envoy8x output.
--- Quote --- Current Conditions for RC Envoy8x
Date: Sat, 05-03-2014
Last Reading: 05:17:39 PM
Inside Data
Inside Temperature: 63.5 °F
Bar: 29.65 in
Inside Humidity: 54
TX 2: RC Envoy8x/Wind_2
Wind Speed: 0.0 mph
Wind Dir: ---- °
Wind Speed 10 min: 0.0 mph
Wind Gust 10 min: 0.0 mph
Wind Dir of Gust: ---- °
Wind Chill: ---- °F
TX 3: RC Envoy8x/Vantage Pro2 ISS_3
Outside Temperature: 41.8 °F
Outside Humidity: 96 %
Wind Speed: 0.0 mph
Wind Dir: ---- °
Wind Speed 10 min: 0.0 mph
Wind Gust 10 min: 0.0 mph
Wind Dir of Gust: ---- °
Dew Point: 41.0 °F
Heat Index: 42.0 °F
Wind Chill: 42.0 °F
Daily Rain: 0.63 in <<<<RG11 Gauge
Last 15 min of Rain: 0.01 in
Last 24 hr of Rain: 0.72 in
Rain Rate: 0.05 in/hr
TX 4: RC Envoy8x/Wind_4
Wind Speed: 0.0 mph
Wind Dir: ---- °
Wind Speed 10 min: 0.0 mph
Wind Gust 10 min: 0.0 mph
Wind Dir of Gust: ---- °
Wind Chill: ---- °F
TX 5: RC Envoy8x/Vantage Pro2 Plus ISS_5
Outside Temperature: 41.7 °F
Outside Humidity: 98 %
Wind Speed: 0.0 mph
Wind Dir: ---- °
Wind Speed 10 min: 0.0 mph
Wind Gust 10 min: 0.0 mph
Wind Dir of Gust: ---- °
Dew Point: 41.0 °F
Heat Index: 42.0 °F
THSWI: 41.0 °F
Wind Chill: 42.0 °F
Daily Rain: 0.29 in <<<<Davis Gauge
Last 15 min of Rain: 0.01 in
Last 24 hr of Rain: 0.37 in
Rain Rate: 0.01 in/hr
UV: ---- index
Solar Rad: 47 W/m^2
ET: 0.000 in/hr
--- End quote ---
Ignore the 24 hour numbers, since I was testing it yesterday afternoon with a spritzer.
Greg
DaleReid:
Greg,
You realize in the State of Wisconsin, you'd need a license to modify the weather. I'd hide your spritzer if you have a similar law in your state....
miraculon:
I treated the clear housing with RainX. Now, things are opposite with the RG11 counting about half of the Davis counts.
Hmmm....
Maybe I should apply for that weather modification license...
Greg
iisfaq:
Hi
I would be interested in how you did this?
I have an RG11 - but not been using it.
Are you willing to share the details on the interface you connected up?
Chris
miraculon:
I used the rain input on a Davis Temp/Humidity station. The pinouts for the Davis rain collector are:
--- Quote ---Input/Output Connections
Black . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Unused
Red . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Switch terminal
Green & Yellow. . . . . . . . . . . . . . . . . . . . . . . . . . . . . Switch terminal
--- End quote ---
But this is somewhat ambiguous. I wired the NO terminals of the RG-11 to match these "RJ-11" connector terminals on a Davis SIM rain channel. Maybe using an actual Davis cable and cutting off one end might be the best bet. I had to use a slightly larger wire than the RJ-11 connector 24 gauge wire since the screw terminals on the RG-11 would not tighten on such a small wire. I soldered short wire stub to the 24 gauge and put heat shrink tubing on it.
I had some trouble at first with the RG-11 not registering counts. I found that I would get a count when I plugged in the connector. I eliminated one of the wires until I got the closure to the rain input to work correctly. Sorry, I didn't document what I did very well. The RG-11 rubber o-ring is difficult to get to seat properly, otherwise I would go and look at it for you. It was somewhat of an ordeal to get it back together properly.
The output that was in my posting is from a Davis Envoy8x, which allows multiple "ISS" units. I have the "real" ISS configured on Station #5 and the Temp/Hum station on #3. The accuracy seems to be variable compared to my CoCoRaHS and Davis gauges. Sometimes they are reasonably close other times, way off. The "RainX" treatment seemed to make an improvement.
Greg H.
Navigation
[0] Message Index
[#] Next page
Go to full version