Hi,
Has anyone had problems with the display getting hard to read unless viewed from an extreme angle
The unit was purchased in August last year, all set up properly (I had had one before but it failed after about 2 years use) and in December last year I went to read it and the display appeared dim, so changed batteries in both sender & receiver reset it all but still dim display, all the data was there but you had to read it from below the screen on an extreme angle.
I took it back to the store & they replaced it under warranty and all was going well until yesterday when the problem has come back again.
The batteries that were in the unit have been tested and were ok, but replaced anyway, also checked was the output from the power pack
This is mounted on a wall inside the house slightly above eye level and can be easily read when passing.
But today the screen display has gone dim again and can only be read on an extreme angle, once again I have changed the batteries in both units (put in Energizer batteries) and reset it no change.
Any suggestions
Cheers from down under in New Zealand