Tomorrow i will replace my 5in1/Hub with a new Atlas/Access and I wondering if there is procedure that will keep MyAcuRite and WU happy. I don't want a new WU Station ID.
Here is what I was thinking:
1) connect the Access to internet and power and allow time for it to download the newest firmware.
2) Add the new Access to MyAcuRite
3) I have 3 Temp/Humidity connected to the old Hub so next I was going to add them to the Access and verify them on MyAcuRite
4) Install the batteries in the Atlas and establish connection with Access and verify on MyAcuRite
At this point I should have both units reporting to MyAcuRite and WU.
5) Turn off the old Hub and enter my WU Station ID and Station key in the sharing area of MyAcuRite for the new Access.
6) Remove the old Hub and sensors in MyAcuRite
Will this work or am I missing something
?