Ok, I found a new skin that I like and it includes the inside temp and humidity BUT, the values are going all weird. The humidity was saying 76% when the sensor is reading 43%. I checked the wxdata file and it matches the 43% so the difference is coming from the driver I think.
I went in and started moving values for " 'inHumidity' : Observation(magnitude=30.0, average=50.0" and they seem to make the humidity value change but nothing consistent. I ended up putting them back to where they were and the reading was normal. No clue why. But now, the reading is climbing again. In the last two hours, it went up 5% over the correct reading.
# The following doesn't make much meteorological sense, but it is easy to program!
self.observations = {'inTemp' : Observation(magnitude=20.0, average= 50.0, period=24.0, phase_lag=14.0, start=start_ts),
'inHumidity' : Observation(magnitude=30.0, average=50.0, period=48.0, phase_lag=14.0, start=start_ts),
'outTemp' : Observation(magnitude=20.0, average= 50.0, period=24.0, phase_lag=14.0, start=start_ts),
'barometer' : Observation(magnitude=1.0, average= 30.1, period=48.0, phase_lag= 0.0, start=start_ts),
'windSpeed' : Observation(magnitude=10.0, average= 5.0, period=48.0, phase_lag=24.0, start=start_ts),
'windDir' : Observation(magnitude=360.0, average=180.0, period=48.0, phase_lag= 0.0, start=start_ts),
'humidity' : Observation(magnitude=30.0, average= 50.0, period=48.0, phase_lag= 0.0, start=start_ts),
'rain' : Rain(rain_start=0, rain_length=3, total_rain=0.2, loop_interval=self.loop_interval)}
Do you know what could be happening? And could you explain what the values are for and how they work?