I have a vantage wirelesspro2 and weatherlink software purchased 2005 with firmware November2004.
Everything has worked perfectly since installed apart from occasional battery replacement.
Because of some roof work i had to take the ISS stand off the roof and the only cable i took out was the one to the anemometer.
When i placed the ISS back in the same position on the roof i had this problem.
The temp sensor unit ( which is further away than the mainISS)was recognised by the console and indoor readings from the console were ok. However i am getting no data on my console from the main ISS.
I have tried new batteries twice
I have checked all leads are attached
The test mode switch was fine with the intermittent flashes
I have tried several different ids for the main ISS
In the weatherlink software i tried the alarm and battery status and was showing no Station battery for the main ISS.
On the vantagepro 2 console strangely in the setup procedure i have on the bottom of the screen STATION no 3 5, so i presume station5 (the mainISS)is recognised. 3 is my temp sensor which works ok and 5 is the main ISS .
During this setup when i go through each station 1 is on, 3 is on but 5 is off. I then change that to ON but when i go through the same set up procedure 5 is OFF again
I am not sure if i have a faulty console or faulty PCBA ISS unit.
Any help would be much appreciated
Philip