Final update.
I reached out to Davis for input as I was stumped. Got it figured out this morning..so I am back in the game.
FYI - if this happens to you. You don't need to update any of the settings with the weatherlink software after you download it again or create a new station ID. Your ISS and console already have the program/station ID
Here are the instructions to change your stations ID. Use this as a reference to check your settings.
Go out to your transmitter and slide off the door, locate the DIP switches to the right of the battery. There are 4.
Look over the diagram below and lets go with ID # 3
cid:image001.png@01CED4B5.F50AAE10
Using a small tool like a paper clip or small screw driver Flip the 2nd DIP switch to the ON position (Up is on, down is OFF). Leave the 1st, 3rd, and 4th DIP switches down (off position)
cid:image002.png@01CED4B5.F50AAE10
Next, go over to the console and set it receive from the ID #3, too.
Go into setup by Holding the DONE button and pressing the " - " button, simultaneously.
The first screen you will see is "RECEIVING FROM", press the DONE button once to get to the Transmitter config screen.
You should see a 1 on the line and below that ON<ISS>.
use the + or to toggle it to OFF. Then, use the > button to go through each ID, 2 through 8, and make sure they read OFF as well.
When you get to ID 3 use the + to toggle it on. It should read "ON<ISS>" with the number 3 appearing on the line.
Press and Hold the DONE button to exit setup.