WXforum.net
Weather Station Hardware => Blitzortung => Topic started by: Fox_Of_The_Wind on June 14, 2014, 08:45:39 AM
-
I got some extra flux on a board what is a easy and safe way to clean it up?
-
I got some extra flux on a board what is a easy and safe way to clean it up?
I use "Flux Off". It works great. I think I ordered it from Amazon or Mouser.
Joe
-
alcohol on a Q tip or small brush
nail polish remover is mostly acetone, that'll work.
If the flux is thick, it'll be brittle and you can chip it off with a sharp soldering aid.
-
Thank you both!
-
Just be certain that you do not get any of the alcohol or other liquids in the buzzer on the controller board as it will most likely ruin it.
-
More soldering information is here:
http://www.lexingtonwx.com/html/soldering.html
-
I got some extra flux on a board what is a easy and safe way to clean it up?
I use "Flux Off". It works great. I think I ordered it from Amazon or Mouser.
Joe
I also used "Flux Off" with the built-in brush. You can scrub the board while you are spraying.
http://www.mcmelectronics.com/product/20-1960 (http://www.mcmelectronics.com/product/20-1960)
(http://www.mcmelectronics.com/content/productimages/s4/3852742.jpg)
Greg H