Author Topic: My Homemade Radiation Shield  (Read 337 times)

0 Members and 1 Guest are viewing this topic.

Offline Garagedude

  • Member
  • *
  • Posts: 8
My Homemade Radiation Shield
« on: February 13, 2017, 09:57:45 PM »
I'm new to the hobby but I thought I would post My homemade radiation shield that I made. So far it works really well and keeps the high readings down. I'm using an Acurite 02007 and its less that 1 deg difference from my neighbors Davis station. When I first put the sensor in it the temp didn't go down but after I turned the fan on, the temp went down to the same as my neighbors so it seems to work good. I put a timer on it so the fan shuts off at sunset and turns on at sunrise. I didn't know if the insulation was needed so I can always remove it real easy. I put the red mesh cover on the bottom to keep bugs and etc out of it. Please leave some feedback so I can learn from my mistakes.

Offline miraculon

  • Sunrise Side Weather
  • Forecaster
  • *****
  • Posts: 2707
  • KE8DAF
    • Sunrise Side Weather in Rogers City MI USA
Re: My Homemade Radiation Shield
« Reply #1 on: February 14, 2017, 08:21:49 AM »
Looks good. My only comment is to make sure you have this on a Ground Fault Circuit Interrupter (GFCI) since you used a 120V fan.

Greg H.




Blitzortung Stations 668, 706 - CWOP CW4114 -  CoCoRaHS MI-PI-1

Offline Garagedude

  • Member
  • *
  • Posts: 8
Re: My Homemade Radiation Shield
« Reply #2 on: February 14, 2017, 08:37:19 AM »
Ok, I hadn't really thought I would need one. That's an easy fix tho. Thanks

Offline Garagedude

  • Member
  • *
  • Posts: 8
Re: My Homemade Radiation Shield
« Reply #3 on: February 16, 2017, 09:53:18 PM »
I added the GFCI and also returned the AcuRite and went with Lacrosse. My readings are dead on now. I'm happy