Topic: honeywell ts34c sensor question.

[rhys.]

hi people.

i have a honeywell te923w station which includes the ts34c temp sensor. it has a LCD display of the temp and humidity, but it has it as Fahrenheit, does anyone know if there is a way to change it to celsius as im in australia and that is the unit we use over here. i've looked high and low on the net and through the user manuals but can't seem to find anything?

any help is greatly appreciated 

[Downlinerz2]

Hi Australia
   Have you tried to remove the back cover where the batteries are?  Hope you find it.  It is confusing.  A website I looked at said it can be changed by user between C & F.  But as you said the manual does not indicate a switch there.   
Good luck,
Mark

[offroadjosh]

i use to have a te923 and  the temp/hum lcd display sensor had a switch under the battery plate=)




Josh

[rhys.]

the switch underneath the battery plate is the channel 1 - 5 , not for the C or F 
maybe there isn't a way to change it. thanks for ur help tho 

[DanS]

Rhys.,

Have you tried;
1. On the main unit/console, Press UP or DOWN until the IN icon on the upper right flashes. This should take you to the Temp and Humidity mode.
2. Press and hold SET to toggle the temperature between C and F.

Dan

[rhys.]

Rhys.,

Have you tried;
1. On the main unit/console, Press UP or DOWN until the IN icon on the upper right flashes. This should take you to the Temp and Humidity mode.
2. Press and hold SET to toggle the temperature between C and F.

Dan

i'll try that and if it doesnt work i will just have to get over it  thanks heaps tho 

[unclemoosh]

Try:

Set the Temperature in Celsius or Fahrenheit.
In Temperature and Humidity Mode, press and hold SET to toggle the temperature in
Celsius (ºC) or Fahrenheit (ºF).

From page 33 of manual located here: http://www.speedtech.com/manuals/TE923W-eng.pdf