Author Topic: 9.2 Firmware Released  (Read 4713 times)

0 Members and 1 Guest are viewing this topic.

Offline gwwilk

  • Southeast Lincoln Weather
  • Forecaster
  • *****
  • Posts: 2573
    • SouthEast Lincoln, NE Weather
Re: 9.2 Firmware Released
« Reply #25 on: January 05, 2019, 09:50:58 AM »
9.2 ran flawlessly on my System RED for a few days.  This morning the GUI crashed when I tried to load another page after the Status Page.

I'm not sure what the problem was, but I back-leveled to 8.4 and set up a daily reboot for the wee hours of the morning. Then I reloaded 9.2 which I hope will run OK with the daily reboot.
Regards, Jerry Wilkins
gwwilk@gmail.com

Offline AF6GL

  • Senior Member
  • **
  • Posts: 82
    • Jeffries Ranch Weather Center
Re: 9.2 Firmware Released
« Reply #26 on: January 06, 2019, 12:25:12 AM »
Now if I only had the hardware to install it on.

Offline miraculon

  • Sunrise Side Weather
  • Forecaster
  • *****
  • Posts: 4107
  • KE8DAF
    • Sunrise Side Weather in Rogers City MI USA
Re: 9.2 Firmware Released
« Reply #27 on: January 06, 2019, 08:23:19 AM »
So far GUI on RED is OK on v9.1.
To recap the changes:
  • Disabled "Auto Amplitude Filter"
  • Enabled LEDs off when LCD off
  • Reverted to v9.1
  • Display: Auto off after 60 sec.

I suspect that v9.2 might be OK, without the already noted issues. I think that the disabling of the Auto Amplitude Filter was the most effective, but others certainly helped.

Greg H.

Although with the countermeasures mentioned, it seemed better, this morning it was back to its old tricks again with a monochrome header only GUI display. Back to v8.4, which is where it is going to stay.

I had some severe unrelated problems with an IP address conflict that was wreaking havoc on my LAN. This was the cause of my inability to re-flash. That was an unholy combination of a power outage, new smart TV and DHCP. Got that sorted.

Greg H.


Blitzortung Stations #706 and #1682
CoCoRaHS: MI-PI-1
CWOP: CW4114 and KE8DAF-13
WU: KMIROGER7
Amateur Radio Callsign: KE8DAF

Offline W0BTU

  • Member
  • *
  • Posts: 49
Re: 9.2 Firmware Released
« Reply #28 on: January 09, 2019, 02:14:51 PM »
I just noticed that remote rebooting no longer functions on my Blue 19.3 station. Not even after powering down for 45+ seconds. Maybe related to 19.2? Can someone please try it and let us know if it works for you?

EDIT: Same thing on my Blue 19.5 station!  ](*,)

Also posted at https://forum.blitzortung.org/showthread.php?tid=2584&pid=20090#pid20090
« Last Edit: January 09, 2019, 05:21:45 PM by W0BTU »
Stations: 1977, 2294

Offline W0BTU

  • Member
  • *
  • Posts: 49
Re: 9.2 Firmware Released
« Reply #29 on: January 10, 2019, 12:07:44 AM »
Too buggy for me. Reverted to 9.1 until it's fixed.
Stations: 1977, 2294

Offline gwwilk

  • Southeast Lincoln Weather
  • Forecaster
  • *****
  • Posts: 2573
    • SouthEast Lincoln, NE Weather
Re: 9.2 Firmware Released
« Reply #30 on: January 10, 2019, 08:58:52 AM »
Firmware V. 9.2 still chugging along here with the daily reboot in the wee hours of each morning.

The reboot is set via a Setting in the firmware.
Regards, Jerry Wilkins
gwwilk@gmail.com

Offline Cutty Sark Sailor

  • WxElement panel
  • Forecaster
  • *****
  • Posts: 3393
    • Frankfort Weather - TwinHollies WeatherCenter
Re: 9.2 Firmware Released
« Reply #31 on: January 10, 2019, 01:49:22 PM »

The reboot is set via a Setting in the firmware.
Jerry, we're talking about this, not the "daily" reboot:
 


Offline gwwilk

  • Southeast Lincoln Weather
  • Forecaster
  • *****
  • Posts: 2573
    • SouthEast Lincoln, NE Weather
Re: 9.2 Firmware Released
« Reply #32 on: January 10, 2019, 01:57:46 PM »
I'm talking about this:

Don't forget to 'Save' this change as reminded at the top of the Settings Page.
Regards, Jerry Wilkins
gwwilk@gmail.com

Offline Cutty Sark Sailor

  • WxElement panel
  • Forecaster
  • *****
  • Posts: 3393
    • Frankfort Weather - TwinHollies WeatherCenter
Re: 9.2 Firmware Released
« Reply #33 on: January 10, 2019, 02:16:12 PM »
I know...
We're talking about the 'tools' page, reboot button not working...the new firmware fixed a remote reboot with
"http://     controllerURL/     index.cgi?action=do_reboot"
but the GUI reboot cmd button now does not reboot the controller"
« Last Edit: January 10, 2019, 02:20:01 PM by Cutty Sark Sailor »
 


Offline gwwilk

  • Southeast Lincoln Weather
  • Forecaster
  • *****
  • Posts: 2573
    • SouthEast Lincoln, NE Weather
Re: 9.2 Firmware Released
« Reply #34 on: January 10, 2019, 02:33:08 PM »
I know...
We're talking about the 'tools' page, reboot button not working...the new firmware fixed a remote reboot with
"http://     controllerURL/     index.cgi?action=do_reboot"
but the GUI reboot cmd button now does not reboot the controller"
Sorry for misunderstanding the problem.  I just tried the 'Reboot' button but it appeared to simply log me off and the GUI was back up after a couple of seconds.  Quickest RED reboot ever... :shock:
Regards, Jerry Wilkins
gwwilk@gmail.com

 

anything